11 sec 95 Z28 4 Sale
11 sec 95 Z28 4 Sale
Details of car:
1995 Z28-40,000 orig miles
T-tops,Tan lthr int, pw,pl, driver seat powr, cruise,tilt,etc.
Runs 11.90's to 12.05's consistently at 6,000 ft ALT.!!!
Engine:
All new parts at rebuild:
355-less than 1k on all parts:
SRP forged pistons-9.0:1
Eagle H-beam rods-forged
Schneider racing cam-236/246@5 595 Lift w/1.6 rockers
Police LT1 head gaskets-9.5:1
Total seal rings
Clevite bearings
Milodon HV/HP oil pump
Stock Crank- balanced
AFR Hydra Rev Kit
Victor Jr. Aluminum Racing heads-ported stage III
2.08/1.65 Valves-these flow.
Dual valve springs
Intake matched porting
Comp Cams hardened push rods-Black
52mm TB w/airfoil
Stock injectors-I know, room for improvement here!
new GM engine mounts
Dyno tuned with LT1 Edit
Custom yellow/black paint theme for fuel rails/intake/block/heads,etc.
Custom dual stage RPM activated NOS setup w/MSD pill module
20lb NOS Bottle w/guage
NOS Bottle heater
NOS pressure guage in pod
All hidden for the most part!
Transmission
Rebuilt-race ready GM 4L60E-less than 1k on rebuild. ( A $3k rebuild).
Built by US Transmission-per them good for 800 RWHP!
New Art Carr 3k UFO stall conv, new pump,clutches etc.-will handle power.
Driveshaft
3" Akuminum Custom w/Spicer U-joints built by Front Range Driveline.
Rear End
Stock housing/axles
Auburn Pro Series posi unit-2.5k on this
US Gear 4.10
MAC Stud Girdle
Suspension:
RKSport:
Adj. panhard rod aluminum
largest avail front and rear sway bars w/poly bushings
tubular trailing arms w/poly bushings
Poly tranny mount
Diamond Sub-Frame connectors-welded on.
Exhaust:
Hooker full length super comp headers-ceramic coated
header locks
2-3" high flow cats w/flanges
2-3" straight pipe cat eliminater tubes w/flanges
2-flowmaster 40 series delta race force 3" w/flanges
Ignition:
MSD 6-AL
MSD GM Blaster Coil
MSD 8mm plug wires
MSD RPM Switch for dual NOS stage setup w/extra pills
Engine Accessories:[/U]
NEw parts at rebuild:
water pump
battery
starter
160 degree thermo
k&N FIPK
Interior:
White gauge faces w/blue lights
NOS Pressure guage
Sport Comp PRO Silver Tach-10k RPM w/shift light
Wheels and Tires:
17" GRandsport rims- 11.0 rear, 9.5 front
285/40/ZR17 Front Nitto-very new
335/35/ZR17 Michelin Pilot Sport rears-very new- Set cost $3k
Also have new set of Mickey Thopmson ET Streets
26x12.5 mounted on stock Z28 rims-10 passes on them
Exterior:
Painted Millenium Yellow from a C5 corvette w black Vinyl stripes on hood and spoiler-black GS rims-looks mean!
I have lots of receipts and pics of this car. Also have timeslips avail.
If interested, make an offer. This car has lots of money and time invested. It would be a good deal considering the mods in it alone. Just looking for a reasonable offer.
Email me to start.
1995 Z28-40,000 orig miles
T-tops,Tan lthr int, pw,pl, driver seat powr, cruise,tilt,etc.
Runs 11.90's to 12.05's consistently at 6,000 ft ALT.!!!
Engine:
All new parts at rebuild:
355-less than 1k on all parts:
SRP forged pistons-9.0:1
Eagle H-beam rods-forged
Schneider racing cam-236/246@5 595 Lift w/1.6 rockers
Police LT1 head gaskets-9.5:1
Total seal rings
Clevite bearings
Milodon HV/HP oil pump
Stock Crank- balanced
AFR Hydra Rev Kit
Victor Jr. Aluminum Racing heads-ported stage III
2.08/1.65 Valves-these flow.
Dual valve springs
Intake matched porting
Comp Cams hardened push rods-Black
52mm TB w/airfoil
Stock injectors-I know, room for improvement here!
new GM engine mounts
Dyno tuned with LT1 Edit
Custom yellow/black paint theme for fuel rails/intake/block/heads,etc.
Custom dual stage RPM activated NOS setup w/MSD pill module
20lb NOS Bottle w/guage
NOS Bottle heater
NOS pressure guage in pod
All hidden for the most part!
Transmission
Rebuilt-race ready GM 4L60E-less than 1k on rebuild. ( A $3k rebuild).
Built by US Transmission-per them good for 800 RWHP!
New Art Carr 3k UFO stall conv, new pump,clutches etc.-will handle power.
Driveshaft
3" Akuminum Custom w/Spicer U-joints built by Front Range Driveline.
Rear End
Stock housing/axles
Auburn Pro Series posi unit-2.5k on this
US Gear 4.10
MAC Stud Girdle
Suspension:
RKSport:
Adj. panhard rod aluminum
largest avail front and rear sway bars w/poly bushings
tubular trailing arms w/poly bushings
Poly tranny mount
Diamond Sub-Frame connectors-welded on.
Exhaust:
Hooker full length super comp headers-ceramic coated
header locks
2-3" high flow cats w/flanges
2-3" straight pipe cat eliminater tubes w/flanges
2-flowmaster 40 series delta race force 3" w/flanges
Ignition:
MSD 6-AL
MSD GM Blaster Coil
MSD 8mm plug wires
MSD RPM Switch for dual NOS stage setup w/extra pills
Engine Accessories:[/U]
NEw parts at rebuild:
water pump
battery
starter
160 degree thermo
k&N FIPK
Interior:
White gauge faces w/blue lights
NOS Pressure guage
Sport Comp PRO Silver Tach-10k RPM w/shift light
Wheels and Tires:
17" GRandsport rims- 11.0 rear, 9.5 front
285/40/ZR17 Front Nitto-very new
335/35/ZR17 Michelin Pilot Sport rears-very new- Set cost $3k
Also have new set of Mickey Thopmson ET Streets
26x12.5 mounted on stock Z28 rims-10 passes on them
Exterior:
Painted Millenium Yellow from a C5 corvette w black Vinyl stripes on hood and spoiler-black GS rims-looks mean!
I have lots of receipts and pics of this car. Also have timeslips avail.
If interested, make an offer. This car has lots of money and time invested. It would be a good deal considering the mods in it alone. Just looking for a reasonable offer.
Email me to start.
No Interest? I have more money in mods than most cars of this year or newer are asking for stock prices. You can have this car for 250.00 a month!! Considering what has been put into it, you can have a stock Z running mid to high 14's in my area, or my car running high 11's for the same price. No comparison!
??????????
Good FREAKIN' luck with that man! 48 months on a 95??? I couldn't get 48 months on my 97 Z with 28k about a year ago!! That's gonna be impossible! (banks don't look at mods) I really don't want to be a dick here, but I just had to get that out. I would like to see pics though, if you want to post a link or email me some to imdabig1@aol.com. Good luck with the sale too.
Re: 11 sec 95 Z28 4 Sale
Hmm...I don't really know about CU's. Thats what I hear is they're alot more lenient on loans, but I checked 2 years ago at Landmark CU (local?) when I was lookin for a truck and they said only 98's or newer and even then, I don't know about 48 mos. Oh well...again, good luck
Re: 11 sec 95 Z28 4 Sale
Ya, I checked around. Lots of banks and CU's will loan out a four year term on this car. A guy on ebay is looking at my car and said he got approved for a four year loan for 8,800 on it. I am not sure if I will take that just yet.
Re: 11 sec 95 Z28 4 Sale
so wheres the pics? how much is tha lowest price ur willin gto take, yea it has a lot of mods, excellent mods at that, but its still a 95, not to be mean, but anything higher than 10,000 will be kind of
, but good luck, im slightly interested but i wanna know the price cuz i could get a modded ls1 for over 11,000
, but good luck, im slightly interested but i wanna know the price cuz i could get a modded ls1 for over 11,000
Re: 11 sec 95 Z28 4 Sale
the lowest price I will take for it is $9800.00 If I dont get that much it is not worth it to me to sell. Lot's of money invested. You would spend more than that to do these similar mods on another car. It's a good car and I will keep it and make it faster if there is no response. Thanks!


