I posted some new pictures of my 1996 Z28 over on LS1tech.com. I don't have my cardomain site going yet so here is the link so you can see.
Enjoy!

http://ls1tech.com/forums/showthread.php?t=273002

 

WOW thats BADA$$

 

Looks really nice, I love the Enkie wheels!!

 

Nice car, props on keeping it so clean. My lil bro just bought some Enkie wheels for his carolla S, they seem like good quality wheels.

 

Nice that's one clean *** engine bay!

 

Thanks for the feedback guys!

 

Your engine bay is unbeleivable. Excellent job.

 

Wow, that is very impressive!! I've never seen such a clean LT1!

What kind of lower springs do you have? The car appears to have a raked look.

 

Looks great. How and where did you route the wires that run over the top of the passenger side? And where are your fuel lines?

 

I have DMS lowering springs. They do give a good raked look along with a really good ride.

I did the passenger side wire mod that a lot of people talk about. I drilled a half inch hole just below the computer and ran then through the wheel well. Since the pictures were taken, I have even hidden the red junction box. I used braided stainless -6AN lines for the fuel lines and used the same routing as the stock but I drilled a couple of holes below the master cyinder and brought them in there and routed them over the top of it and to the back of the intake, kind of hiding them. It cleans the engine bay up a lot.

 

Dude, that is awesome. You've done a GREAT job. I applaud you!

 

wow, that looks great, what was needed to fit 315's on the rear wheels. Might look into buying a set of these locally from a guy if its not too much trouble.

thanks

 

Well, the 315's in the rear on 17x9.5 inch rims is a whirlwind of controversy. Some people say it is unsafe and some say that it looks bad and you won't get the full tread width of the tire, etc. I like it and think it looks good. I did it for looks, it is not a daily driver or a road race car so I am not worried about it. Thanks for the comments.

 

Lookin good man, I love all the chrome under the hood

 

joshp007,

Here are some better pictures of how the AN fuel lines are routed and are attached.

http://img212.exs.cx/my.php?loc=img2...ture0040hg.jpg

http://img212.exs.cx/my.php?loc=img2...ture0032ih.jpg