Hey guys, I hope i'm posting this in the right spot. If you all missed my introduction, my names Kyle Milefchik. I am 16 years old and own a 1975 Camaro. I got the car when i was 13 with 58,000 original miles from the original owner. I spent the last 3 years building it with the help of my grandpa and uncle and a few friends. So I thought I would share my build with you guys.

 

One of the first things I did was change wheels. My grandpa had a set of like 30 year old Cragar dragstars that were brand new. He was nice enough to give me them for the car.

 

There was some rust damage in the rear quarters and in the front passengers side fender. Also, the entire rear valance was rusted out.

 

this was when about 85% of the body work was done.

 

 

Then we added a steel 2 inch cowl hood.

 

after that, it was time for paint, so we stripped it down to bare metal basically

 

 

after a lot of color sanding, it finally got outside. The chrome at the bottom was still at the chrome shop getting straightened out

 

I got a new edelbrock intake setup as well...that two barrel just wasnt cutting it!

 

Trim came back. I also found a 76 Type LT Aluminum panel for between my taillights

 

I went out of town for the weekend with my Uncle, Aunt, and Grandpa for Back to the 50's weekend car show in St. Paul, MN and I came back on sunday and my uncle had to pick something he ordered up from my work. So i walk in the shop and see my camaro up on the lift. My buddy Todd had trailered my camaro over to work while i was gone so my boss could put my Dynatech headers and polished stainless exhaust on the car. everyone in my family knew about it except me! What a nice surprise to come home to!

 

Very nice work!!

 

Very nice, thanks for all the pics

 

Thanks guys!