i was wondering if anyone knows where to buy the black rear panel that goes right where it says CAMARO in the back. if any one knows what im talking about please write back thanks

 

It's commonly referred to as the "Berger panel" and it's just the stock rear panel, simply repainted (usually satin or flat black). All you need to do is take yours off and get it sprayed, or paint it yourself.

If you don't want to paint your current rear panel, try junk yards or check around on the boards for someone selling theirs.

 

There's usually a high number of rear panels being sold on the boards at any given time...some already painted black, others may not be. I've seen many of them go for the fifty dollar range.

 

I know of this one board that helps a lot... ....CZ28...something... oh!..


What color is your car? I might be able to dig up some pics for ya to give you an idea....

 

I bought one off a member on this board that was parting out a black car... thatsw the best way to do it

 

how hard is it to R/R the panel? been thinking about it, but i have never done any type of body work.

 

Remove the tail lights by unscrewing the plastic wingnuts on wach light then remove the 4 10mm nuts on the rear panel. One in each corner and one on each side of the middle. To install just do the reverse. Takes 5 min to remove and 2 min to install

For body work check out the write up i made in my sig. it isnt finished yet but you can get a general idea of the procedures. I will have pics up tomorrow.

 

wow, that is much easier then i was expecting. i, for some reason, thought you would have to take the bumper off to get the panel out.

thanks for letting me know that, going to order one soon.

 

found one camaro in daytona area, sure enough it was actually black. woot. has some minor scratches, but the lady dropped it and put a nice 3 inch gash under the driver taillight.
after i wash the car ill post some pics.

 

[IMG][/IMG]
[IMG][/IMG]

taken with camera phone and the sun was against me.

 

Just do it yourself, why spend 50 bucks when you can get it done for a fraction of that.

 

forgot to mention that i bought this one at a junkyard for 35$.

just good to have the factory panel if need be.