Billet grill picture requests.
I decided to put electrical tape on my billet grill to see how it looked black and I have to say I love it! The powdercoating on it has started to chip off so I'm just going to repaint it all black.


As for how it mounts. I would have to have one that will either mount to the fog light brackets, or to the upper/lower/outer bumper, not the inner grill section. I will be cutting that part out shortly for my FMIC. Thats the reason I want a grill, to kind of hide the intercooler.
Had to drill holes in the grille, paint some screws black, then just screwed into the facia all at once. Didn't predrill any holes in fiberglass of facia so as allow for a good, tight fit. Used rubber washers to serve as spacers and offer some give as well.
HTH
-John
HTH
-John
Is there any way to mount the grill to the upper and lower section of the bumper instead of the middle part with the bowtie on it? I plan on cutting this section out and probably deleting the fog lights too, for better airflow to my FMIC. I want a grill to kind of hide the FMIC and clean things up a bit.
Thread
Thread Starter
Forum
Replies
Last Post
2000silverz28
Car Audio and Electronics
0
Sep 7, 2002 01:48 AM
2000silverz28
Car Audio and Electronics
5
Jul 20, 2002 06:14 AM
FormerPony
Show and Shine / Paint and Body Care
0
Oct 14, 2001 08:05 PM



I think this emblem was for a 69 Camaro.




