angle of the bottle.......
putting on my new NX kit(thanks Aaron) and I want to put the bottle in the sparer tire well. Does it matter how much of an angle you put the bottle at,45* 37* or whatever angle the mounting brackets put it at. I want to put it as close to the bottom of the well as possible. I know about the alignment for the siphon tube p\u if I go all the way to the floor looks like the bottle will be like this \ is that too much?
------------------
96Z M6, 12 bolt Moser(3.73),Star stage 2 kevlar, SLP CAI,!maf,LT4 NM,Flowmaster,Hurst roll control,BFG DR's,Pro 5.0,BMR DS loop...
13.52-103.8 mph
60ft. 1.99
__________________
96Z M6,fresh 355 eagle rotating assembly,SRP 11.1,LE2 heads and cam,1.6RR,guide plates,holley 58mm t/b,#30 SVO's,!AIR,!EGR,mac headers,CSI w/p, 12 bolt Moser(4.11),bmr lca's,NX wet kit,MSD 6AL,,Star stage 2 kevlar,pcmforless programing, SLP CAI,ported maf,,Flowmaster,line lock,BFG DR's,Pro 5.0,BMR DS loop,160 stat.....
1/8th...7.85@92mph spinning on stock motor with alot of spray. No times on new setup....yet 
|
Linear Mode
