Cup holder
#11
Re: Cup holder
I've always been amazed that we have 4 cupholders.... I agree the console one is aweful for M6 guys - I NEVER use that one, only cupholder that is allowed to be used is the one that swings out - that way if the drink is dirty or sticky, etc. it gets on the wire that holds it in cup holder or falls onto rubber floormat. I learned this because there was once a girl who I believe held her shake and to be nice I put mine in back cupholder(s) and it made a little lake in there I had to clean then apply protectant again the next day. Ever since then, only the spring one. If bringing food from somewhere, passenger is required to hold their drink over their lap to not spill on seat and mine goes in the spring swing holder. And of course, there is absolutely no drinking in the car unless it is water only (which, of course, must be filtered). On a side note, I got my first speeding ticket today (93/55) - just had to get that off my chest.
#13
Re: Cup holder
i tried to make a cover, but it didnt com3e out too good. to do it right, you would acutally ahve to mold one. i only alloow bottlwed water in my car, cap on at ALL times...unless the car is OFF. and i usually stick it in one of the cup holders behind the seats.
#15
Re: Cup holder
I dont use the swing out one becausae im afraid i will hit a bump and it will break off. and the other one just gets in the way. i am in the process of moving, but after i do, i am going to make a mold, and an insert that goes into the cup holder. ill post pics of that later.
Thread
Thread Starter
Forum
Replies
Last Post
Noct
General 1967-2002 F-Body Tech
2
07-14-2015 01:18 AM