Hi Guys,

I've got a nice sealed sub box that fits in the well of a third gen and extends to the bottom. It's cut for 2 10s, but should take 2 12s w/o a problem.

The box was a pre-fab box made by a company called DB Speakerworks. It's particle board (not MDF) but seems to be of good construction and is relatively light for a box this size. It is angled up a bit (see pics) and is covered in the typical gray carpet. The nice thing is, it has a few inches of room underneath it for an amp or crossover, and you can still get the little compartment open back there. Unfortunately I don't know the volume of the box.

I bought it off this board a couple years ago and I never even hooked it up. It's in like new condition.

You can see pics here

http://chuma.cas.usf.edu/~syoder/forsale/

I'm located just north of Tampa (Lutz/Land O' Lakes) and would rather sell it locally than ship it at this time.

I'm asking $75 OBO....

Thanks

 

Do you want to sell that Tach out of that gage cluster?

Tyler

 

I'll probably sell the whole cluster, but if you're interested in the tach I'll consider offers? I believe it's got the higher redline that the HO TPI 305s and all the 350s get (5500 rpm?).

 

I just need the tach 40ish???

Tyler