Crap

well my nozzle was put in my stock rubber elbow which after time cracked and loosened up the nozzle, well i have been hunting my stumbling, sputtering problem which seemed to occur right after the nitrous install. I thought the hole in the bellow was the culprit but i replaced that with the trick flow (shiny :bow: ) which did improve the cars performance, noticeably. however, when i looked on the inside of the stock elbow and looked at the nozzle, it wiggle itself around and was facing the MAF...:eek: :eek: can spraying a wet shot on the maf do damage to it? im pretty sure it can, and my o2's are gone. so what do you guys think?

I doubt it damaged your mafs. It probably spun around while you were removing it. Otherwise you would have noticed the lines were crossed over each other. Or maybe not.

hmmmmm... does spraying fuel onto the maf sound like a good idea:(

i dont think so

is stumbling/sputtering symptoms of a bad MAF?

I would spray a wet kit in the wrong direction. what would happen the the fuel?