Wish this warmer weather would hold on

With the warmer temps I've been able to get the pole barn warm enough to spend a couple of afternoons out there.
Friday I got the restalled converter and trans installed.
Today I put the drive shaft, DS loop, and G-load brace back in. Then I prepped the subframe connectors and body and clamped them in place. Tomorrow I'll tough it out and weld them in.

Lots more to do.
QA1 kit....install
exhaust....add bullet muffler
plugs.....almost 20,000 miles on these
air bag....install and hook up Where can I get the air fittings???
2 step....install then test the whole shebang

So I need some more of the warmer days:mad:

No, you just need heat ;)

We're putting a new furnace in the house...then the 120k BTU monster in here now goes out to my garage woohoo!

[QUOTE]Originally posted by Timberwolf
[B]No, you just need heat ;)

I've got heat.:)
What I don't have is a ceiling or insulation.:cry:

Originally posted by Killerjello
ive been wanting to get out and pully my tranny the past couple days,
once that water dries up, im gonna have to haul ass to pull it before it gets cold again...

Too late, it's already cold again:mad:

But I did get the subs welded in today:D