Any Local Exhaust Shops That Can Do 3 1/4" or 3 1/2" Mandrel Bends?

I'm looking to fab up an exhaust turndown for my car, and I need a 3 1/4 inch to 3 1/2 inch I.D. mandrel bent 30 to 45 degree turndown exhaust pipe. Any local exhaust shops that can do mandrel bends on 3 inch plus exhaust pipe?

Would prefer northern suburbs or eastside locations if possible. :)

Thanks! :D

I'm looking to fab up an exhaust turndown for my car, and I need a 3 1/4 inch to 3 1/2 inch I.D. mandrel bent 30 to 45 degree turndown exhaust pipe. Any local exhaust shops that can do mandrel bends on 3 inch plus exhaust pipe?

Would prefer northern suburbs or eastside locations if possible. :)

Thanks! :D

Are you looking to drop your car off at a shop or just take the exhuast pipe down to them??? Because theres a truck repair shop near my house that can do those mandrel bends for you on 3"plus exhuast pipe. It's a truck shop that deals with large trucks. They got the job done on my fathers exhuast for his 69 camaro big block. He has 3 1/2" exhuast. Then again we took the exhuast to them.

Diamond Fabrication
23156 Groesbeck Hwy
Warren, MI 48089
586-443-5297

Detroit1994z28, no this is definitely NOT a drop "off the car" deal. All I really need is a shop that can supply about a foot long piece of either 3 1/4" or 3 1/2" I.D. exhaust pipe, and put about a 45 degree mandrel bend in it.

Where is the truck repair shop that you're talking about located?

Thanks to all who replied, and IROC5.7TPI, I'll also keep Diamond Fab in mind too! :D