|
||
6" rod for Turbo motor?ProchargedLT1 09-21-2006, 02:17 PM I was looking into going back to FI and was wondering if a 6" rod would be ok for a 355 turbo? My motor is setup for NA currently and all I was going to do was swap out for a set of dished pistons and go back FI. I noticed that diamond makes an FI piston for use with a 6" rod so I guess its not unheard of. Thank you for any help. L8er :) jerminator96 09-21-2006, 02:39 PM A longer rod will only get you into trouble with stroker motors. Obviously if you have 3.75 stroke and a 6in rod as opposed to 3.48 stroke thats .27" less in the thickness of the piston. It doesn't really work out that way but you get the idea. The only problem you may have is if you wanted to run a -33cc piston or something similar. Not sure if they make those for a 6'' rod:shrug: ProchargedLT1 09-21-2006, 02:41 PM Its a 3.48" stroke. :) jerminator96 09-21-2006, 03:16 PM Yeah I know, I was just trying to explain to you why it shouldn't be a problem and where it might be:) xxsaint69x 09-21-2006, 10:14 PM A longer rod will only get you into trouble with stroker motors. Obviously if you have 3.75 stroke and a 6in rod as opposed to 3.48 stroke thats .27" less in the thickness of the piston. It doesn't really work out that way but you get the idea. The only problem you may have is if you wanted to run a -33cc piston or something similar. Not sure if they make those for a 6'' rod:shrug: diamond racing makes -31cc of the shelf piston for 6 inch rod :) Thats what is in my car :p jerminator96 09-21-2006, 10:42 PM diamond racing makes -31cc of the shelf piston for 6 inch rod :) Thats what is in my car :p Well there you go then, 6in rods are good for boost:D | ||