Abs inop and low traction light on?

Hello i have a 95 z28 and when i drive the abs inop light comes on but the brakes are fine and also when i apply the brakes and i am almost to a full stop the brake pedal will fall a little bit and the low traction light comes on but the car does stop. I dont know what is the problem. Any advice would be helpful. Thanks.

I had this issue; the rear ABS sensor that's mounted in the top of the differential got dirty. Remove and clean the sensor.

Alright thanks ill try that monday.

I pulled out the sensor on the diff in the back and the sensor was clean, so now what do i do?

your center brake light good?

if it is, you need to get the codes pulled from the ABS module(EBCM/EBTCM)

your center brake light good?

if it is, you need to get the codes pulled from the ABS module(EBCM/EBTCM)
What kind of scanner do you need to get the codes? Do they loan it out at Autozone?

What kind of scanner do you need to get the codes? Do they loan it out at Autozone?
you need one of the more expensive ones(mastertech, tech 2 , ect.), AFAIK, they don't have them at autozone

So i would have to have my mechanic check for codes right?

So i would have to have my mechanic check for codes right?
yes

Alright thanks ill keep you updated with what code i get.

did you clean the sensor or just look at it? if you didnt clean it, spray it with brake cleaner or electronics cleaner. most likely it has small metal shavings on it since it is magnetic

Actually when i looked at it, it didnt have any metal shavings at all.