LT1 Vortech guys inside Please

I am going to sell my blower, so I am removing all of the components of the kit. Does anyone know the size of plug that I need to plug the oil pan where it has been tapped for the oil feed and return lines? Also, whats the best way to get those brass fittings out of the oil pan. The feed line seems to be in there pretty good, I tried wrenching the sh*t out of it. What if I were to take off the hose itself, and leave the fittings in there? Anyone know what size/ type of plugs I would need? TIA

call vortech or checkout there install pages and it will tell you the size of the fitting that went into it

When I had my blower off for a long time, I just put a rubber cap over the end of the oil pan fitting and secured it with a hose clamp.

A 3/8 NPT plug should be used for the drain. And I believe the feed is a 1/4 NPT plug. :)

thanks guys!