Flowmaster American Thunder series muffler with tail pipes and chrome 2 1/2'' SS tips. Tail pipes are not attached to muffler. $100

Brand new set of Speed Pro Forged pistons for a 355. .030 over to be used with a 5.7 inch rod. $150

Sealed Power rings new in box. 4.00" bore. $50
Opened box to look at rings but they are brand new

LT4 Hot Cam NIB. $150

Comp 914 valve springs, 10 degree locks/retainers and hardened pushrods. $90

Crane Gold Race 1.6 rr's $200

Freshly prepped LT1 block. Cleaned, new freeze plugs, oil gallery's, cam bearings. stock bore at this point. $200

Stock pistons/rods/crank. pistons still on rods. no rings on them. had bought above rings to put on but never got around to it. Make off on this stuff.

Have lots of stock stuff. Just ask if there's anything you need.

Pics to come soon

 

I assume the springs match the cam? May be interested in block, cam springs, pistons and rings. Where are you located?

 

Located in TX. now you do realize the sealed power rings won't fit those speed pro pistons? different bore size. let me know though.

 

My bad. Need to pay attention to detail. What is the part number on the pistons?

 

http://www.jegs.com//cgi-bin/ncommer...37&prmenbr=361

 

I am knidas new to the LT1 platform. The stock heads are 58cc aren't they? So about 10.5 to 1 compression?

 

Yes the stock heads are 58cc. Should be about the same as stock compression ratio.

 

are the 2 top piston rings 2 different sizes, the 4 .00 inch set

 

if u have a stock oilpan pm me-thanks

 

Where at in Texas, Interested in the Block.
Let me know at Skullz6911@Hotmail.com
Thanks

 

how much for the crank, pistons, and rods shipped to 79065? Also how many miles on them? Thanks

 

What would you take for the cam and rockers shipped to 31909?

 

Sorry haven't been keeping up with this thread.

I have sold the following.

Heads
Block
Cam/springs/locks/retainers/pushrods
RR's
Crank

I do have another complete rotating assembly
Stock crank, forged rods/pistons but I honestly am not sure on the brand so I'll probably let these all go cheap once they are available I'll let everyone know.

 

money should be thre for the cam and rocker monday or tues day thanks

 

do you have the heads or an intake?