How much Nitrous..

How much could a relatively stock internally rebuild 3.4L handle, will have ported heads, upper and lower intake and ported tb, headers and a couple of other bolt ons. It might also have a cam..I just want an idea of what i should be able to achieve.Thanks

i wouldnt go above a 75 shot... personally, if its just for fun, 50 shot max!

I concur.

75 MAX on a rebuilt 3.4.

Well,since they came with less HP than my lawnmower,I would start at ATLEAST a 400HP FOGGER set up.

hahaha iight guys thanks

I have head form one of the nitrous companys that you can go up to 20hp per cylinder.

what company did u hear this from? and did they mean a stock engine ?

Well,since they came with less HP than my lawnmower,I would start at ATLEAST a 400HP FOGGER set up.
funny, the dildo i bought your wife had more HP than your lawnmower

note, you might wanna E.D. checked out
I have head form one of the nitrous companys that you can go up to 20hp per cylinder.
thats rediclous, 120 on a 3.4L HAHAHAHAHA maybe with forged pistons, bigger injectors, fuel pump.. and the list goes on

I don't know, those seem like awfully small numbers... I know guys that are throwing 100shots on their 2.2L Eco with no internal mod's. Even my Cav can handle a consistent 75 shot.

1st off.. good 1 atl, that was funny haha

2nd.. Idk i hear different numbers from everyone. That tim guy ran a 90 shot fine, then other people tell me 50 shot max, others say a 75 is fine..

<shrug> o well, ill start with a 50 shot and go on from there

I think the 20 per cylinder was from ZEX.
Not a hole lot if you look at a sparying 4 cyl, or a LT1.
NOS claimed not to add more than 50% hp with nitrous.
These are old numbers I don't know if they still use them.

I don't know, those seem like awfully small numbers... I know guys that are throwing 100shots on their 2.2L Eco with no internal mod's. Even my Cav can handle a consistent 75 shot.
yes they are small #'s . but there were a few people on here a few years ago that all lost a piston or 2 (generally # 5 or 6) when spraying over a 50 shot

i wonder how much you could throw at the motor if you were using a direct port kit..... hummmm..... i might end up doing that before i put my new motor in in around a year (hopefully)

Our plenums were never ment to have fuel sparyed in them.
It could puddle.
With direct port you can go way higher.

On the bottem of page 3 (http://www.cardomain.com/memberpage/513476/3) of my cardomain site I posted my 3 stage nitrous control, it's just the schematic.

wonder if i could do a rebuild for my 3.4 to hold 200 shot

yes you can, it wouldnt be that hard really... the rods and crank are forged, so they should take the abuse, you'd need new fuel pump, pistons, a cam suited for the bottle, head studs, chromemoly rings, and a little more, but its do able... its never been done to my knowledge... but it could be