jay christopher
07-11-2002, 10:34 PM
im in the process of converting to a soild roller cam set up. i want to run a billet cam becuase of the high spring pressures i will be running. i know that gtp and others use them all the time, so my question is, does everybody convert the oil pump drive gear to a brass one? my good freind, an "old school" racer says this is a must with billet cams and a distributer,but we only use it as a oil pump drive in the lt1. so does this make a difference? thanks much for any help, jay
OneFlyn95z28
07-12-2002, 12:03 AM
Jay not really an advanced Question but I have tha answer http://web.camaross.com/bb/wink.gif
GM used Billet cams from the factory so I will say yes http://web.camaross.com/bb/wink.gif The Gear is fine on the Billet
------------------
Ellis
Team Captain
Team North West F-Body
www.teamnwfbody.org (http://www.teamnwfbody.org)
[This message has been edited by OneFlyn95z28 (edited July 12, 2002).]
kmook
07-12-2002, 07:15 AM
Since this really isnt that adv of a question, like Ellis broght out, i will get this over to LT1 Tech.
------------------
Ken Mook - 97' SS #2544
Advanced Tech Posting Guidelines (http://web.camaross.com/cgi-bin/ubbmisc.cgi?action=getannounce&ForumNumber=30&Start=2452276.99&End=2453736&Session=)
Almost Alive: ?rwhp & ?rwtq Naturally Aspirated on the Stock Bottom End.
Stage 3 Pro Performance Heads, Solid Roller 242/248 Cam, Endur-X Lifters,
Jet Hot Hooker LTs, True Dual 3" Exhaust with x-pipe, and the list goes on and on (http://www.geocities.com/kmook123)...