FS: complete LT1 from intake manifold to oil pan
Thread Starter
Registered User
Joined: Feb 2003
Posts: 1,661
From: Frisco TEXAS
FS: complete LT1 from intake manifold to oil pan
This motor has about 92000 miles on it. The motor never leaked any oil, so no worries with the rear manifold or rear main seal leaks which plague alot of LT1s. Motor is 100% stock. NEver even been opened up at all. The only thing I ever ran on it was a K&N FIPK and Hooker Longtubes.
I would like to get "around" 600.00 for the entire motor. This will run, guaranteed, on first start up.
I would like to get "around" 600.00 for the entire motor. This will run, guaranteed, on first start up.
Thread Starter
Registered User
Joined: Feb 2003
Posts: 1,661
From: Frisco TEXAS
Re: FS: complete LT1 from intake manifold to oil pan
Oh and the only reason why I am selling is because I am putting a solid roller 383 LT4 motor into my Trans Am right now. I figured it would be best to start with a already disassembled block to do the build up with.
Thread Starter
Registered User
Joined: Feb 2003
Posts: 1,661
From: Frisco TEXAS
Re: FS: complete LT1 from intake manifold to oil pan
Right now, I don't want to part, but if I do part (which I should know in about 3 weeks) then you are first in line for the block.
Thread
Thread Starter
Forum
Replies
Last Post
chevroletfreak
LT1 Based Engine Tech
202
Jul 4, 2005 05:00 PM