CamaroZ28.Com Message Board - Search Results

 
Search: Posts Made By: gaedbo
Showing results 1 to 25 of 193
Search took 0.03 seconds.
Forum: Cars For Sale
09-18-2017, 09:24 PM
Replies: 4
Views: 1,191
Posted By gaedbo

Re: Help pricing 95 Z28?

I sold mine a couple of months ago in Minnesota for $4444. There was nothing wrong with it. It had about 146,000 miles on it. The interior was perfect. T Tops with the shades. Flowmaster...
09-08-2017, 06:11 AM
Replies: 15
Views: 1,303
Posted By gaedbo

Re: infamous rear intake oil leak

Here is what I did.....A Test Run

Install the intake gaskets on both sides.

Install the studs (Remember, after the intake is in place, and you install a couple of bolts loosely to keep it in...
09-06-2017, 09:00 PM
Replies: 15
Views: 1,303
Posted By gaedbo

Re: infamous rear intake oil leak

I used the Shbox method with the ultra-copper and the studs with great results. If you don't use the studs, one little movement in the wrong way and your install could be all for nothing, and you...
08-22-2017, 05:04 PM
Replies: 19
Views: 1,666
Posted By gaedbo

Re: Scan 9495 results

I don't know if this is the same problem I had, but here is some information that may be helpful to check on some things related to the Smell of Fuel.
...
07-29-2017, 07:18 PM
Replies: 4
Views: 319
Posted By gaedbo

Re: Antifreeze/Coolant - What Do You Use, and Why?

ok, you got me on that one. LOL
07-29-2017, 04:20 PM
Replies: 4
Views: 319
Posted By gaedbo

Re: Antifreeze/Coolant - What Do You Use, and Why?

Complete Coolant Flush requires less than 2 gallons of water with 2 gallons of anti-freeze (About 15 quarts total of a 50 / 50 mixture).

It will help your engine run cooler in the summer, and from...
07-28-2017, 05:47 PM
Replies: 38
Views: 2,823
Posted By gaedbo

Re: Mystery LS1

Thanks Injuneer, I wasn't aware of this.
07-28-2017, 08:57 AM
Replies: 38
Views: 2,823
Posted By gaedbo

Re: Mystery LS1

Not sure what you mean by a hoop, and where it is located on the drive shaft, but on my 95 Z I had a Propeller Shaft Slip Yoke, see the Photo. I had it removed, and the drive shaft rebalanced along...
07-23-2017, 06:39 PM
Replies: 6
Views: 471
Posted By gaedbo

Re: spacer for gas pedal

Why not pull the boot off the throttle body and check it like Injuneer is suggesting. If you don't actually look at the Throttle Body Blades you are only assuming you have done it correctly. Only...
07-21-2017, 08:07 AM
Replies: 10
Views: 503
Posted By gaedbo

Re: i need some basic help, for a coolant recovery tank

[QUOTE=scottpdx2010;6993973]thank you for the idea, I do have a problem with the coolant sometimes spilling out of the
overflow tank.

Curious, are you saying coolant is escaping where the Cap...
07-19-2017, 04:12 PM
Replies: 3
Views: 229
Posted By gaedbo

Re: Z28 Convertible Rear Window??

If you don't get a response from here, maybe try visiting a local shop that installs and repairs convertible tops.
07-16-2017, 10:37 AM
Replies: 4
Views: 518
Posted By gaedbo

Re: MSD or stock coil

From Shoebox's #2 Post, he indicates you should be good to go unless you just happen to get a bad one like his first one. They don't have the bad reputation like the Opti's do. Looks like you...
07-15-2017, 03:16 PM
Replies: 12
Views: 604
Posted By gaedbo

Re: 94 Z28 Camaro High rpm knocking Huge Adv Retard Knock

I had a knock retard problem with my Z28. Injuneer suggested that it may be noise generated, possibly with my exhaust system or motor mounts. I found that the threads on one of the exhaust pipe...
07-15-2017, 07:32 AM
Replies: 38
Views: 2,823
Posted By gaedbo

Re: Mystery LS1

I think you'll find the casting number below the rear of the driver's side head.

If you can't see it from above, you might have to view it from under the car.
07-14-2017, 08:08 PM
Replies: 18
Views: 5,275
Posted By gaedbo

Re: 2002 Z28 automatic upgrades?

You can get overlays like that from

Vinyl Overlays, Inserts, and Graphics for the Camaro / Firebird / Trans Am (http://www.bfranker.badz28.com/vinyl/vinyl.htm)

Scan down the page to view the...
07-11-2017, 06:08 PM
Replies: 3
Views: 412
Posted By gaedbo

Re: I had no idea......

Be extremely careful that you don't get the Optispark Distributor wet. It doesn't like water, and you could end up with some real problems afterwards if water gets inside.

Moisture inside the...
07-11-2017, 03:04 PM
Replies: 3
Views: 424
Posted By gaedbo

Re: What the heck are those "jacking pads" called??

I just took the drivers side one off of my 95 Z28 to see if I could help out with this issue, but unfortunately there are no part #'s or anything on that part. Not even some kind of indicator for...
07-06-2017, 03:37 PM
Replies: 15
Views: 1,362
Posted By gaedbo

Re: Replacing a water pump on LT1

#213-4396 is the Sensor located in the Water Pump for the PCM

http://shbox.com/1/temp_sensor1.jpg

The 213-77 is the one located on the Left Hand Cylinder Head for the Gauge.
...
07-06-2017, 12:38 PM
Replies: 13
Views: 362
Posted By gaedbo

Re: Water Getting In Intake When Raining??

So if you know that whenever it rains your engine gets wet, why aren't you addressing the problem ?

Why wouldn't you at the very least put a cheap plastic cover over the entire car!
Summit sells...
07-05-2017, 01:35 PM
Replies: 13
Views: 362
Posted By gaedbo

Re: Water Getting In Intake When Raining??

I hope I am wrong, but this sounds so bizarre that it is some kind of a bad joke.

With my limited knowledge, it just doesn't sound like a engine could be running with water inside the intake,...
07-02-2017, 07:51 PM
Replies: 7
Views: 417
Posted By gaedbo

Re: Throttle Body?

Others hopefully will jump in, but from what I remember from reading other threads/posts, going to a 58mm TB will not do you any good on a basically stock engine.

I believe the 52mm is more than...
07-02-2017, 05:17 PM
Replies: 7
Views: 417
Posted By gaedbo

Re: Throttle Body?

If you aren't familiar with the removal and install of the Intake, you may want to check out this website for some help or tips. Under items #6 and #7 Cam Removal and Cam Install there is the info...
06-28-2017, 09:37 AM
Replies: 12
Views: 604
Posted By gaedbo

Re: 94 Z28 Camaro High rpm knocking Huge Adv Retard Knock

Maybe, just maybe if you replaced all of the wires you have a couple of them on the wrong location on the Optispark Distributor. Just take your time and do a double check to make sure, if you...
06-25-2017, 08:48 PM
Replies: 37
Views: 4,961
Posted By gaedbo

Re: F2 427SBC '69 Camaro

Wish it was mine ! Man that looks awesome !
06-23-2017, 08:19 AM
Replies: 11
Views: 558
Posted By gaedbo

Re: Strange fan behaviour

Seems like you should do Injuneers suggestion in Post #6 and trace the wires from the switch in the ashtray to where they go to help you figure this out !
Showing results 1 to 25 of 193
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.