These are tickflow Chromemoly pushrods. I ran these with my LE2 heads and cc306 cam. The heads I had were not milled, so these are pretty much stock pushrod length. You can run these with stock heads just fine. The length is 7.150 x 0.080. They are in good condition and have maybe 3000 miles on them. I am looking at getting $60 obo shipped for them. I paid $90 new for these from summit racing. If interested PM me or email me at craigs96formula@yahoo.com.

 

Stock is 7.200, those are .050 short. Better with milled heads. Valvetrain geometry DOES matter.

 

Thanks for pointing that out, I can say I ran them on my car with 1.6 rr's on stock heads with the cc503 and put down 340rwhp (for about 1000miles), however I did run thinner gaskets (impala gaskets) and then ran them on my c306 LE2 heads and put down 384rwhp I never had a problem with them, doing a search on here it looks like most guys are running either 7.200 or 7.150.

I will agree Valvetrain geometry does matter, so I appologise, these will be better with milled heads then.

 

50$?

 

back to the top

 

whats the least on the push rods?? so these will fit on stock head with 1.6 rr

 

They are a little shorter than the stock pushrod length.

Back to the Top.

 

ttt

 

been a while, still have them so back to the top.

 

to the top.

 

sale pending.

 

Sold.