I have a set of ported lt1 heads, factory casting with PAC-918 springs, and titanium locks and retainers, along with ARP rocker arm studs and Ferrea valves. I have flow sheets from GRE Race Engines, they are 55cc, flow about 250 cfm. Great for a stock shortblock or something with a hotcam. I'm looking to get $800 shipped or best offer.

 

BUMP IT UP!! have a flow sheet for these as well!!

 

Could you send me the flow sheet? Jeffreysandusky@yahoo.com

 

e-mail on its way

 

please send a floe sheet here as well.

paul.steepe@hp.com

 

please post the flow sheet and any specs you know:
spring installed height / seat pressure
coil bind height / open pressure

how much use on springs? valves?
since valve job was done?
new or knurled guides?
3/8 or 7/16 studs?

this would save being asked a dozen times
Plus, I want this info! Sent pm on other board..
thanks

 

you know...that's a great idea. I was having a hard time converting it to a picture but I figured it out.

Here it is...

 

I never ran these heads on my car but according to the guy that I bought them from, they have approximately 1,000 miles of run time since all the work was completed.

So far all requests have been replied.

 

bump it up!!

 

$775 shipped!!!

 

To The top!!!

 

sold!!!