LT1 355 Forged rotating assembly Never used - Eagle & SRP: 24cc dish, H-beams
#1
LT1 355 Forged rotating assembly Never used - Eagle & SRP: 24cc dish, H-beams
Hello, I have for sale a NEW forged rotating assembly for a SBC LT1 engine. The parts were weighed and balanced, 2 pieces of mallory in the crank, the pistons and rods were all numbered. This was a complete balanced set that I was about to have built for my 1994 Trans Am (going procharged) but decided last minute to go with a 383 instead. The parts are all in new condition, but I did not get the original boxes back from the machine shop.
- Eagle 4340 forged 350 crank (I believe it only is meant for a 1 piece rear main motor only) 3.48" stroke
- Eagle H-beam forged rods CRS-5700-BS with ARP fasteners
- SRP 40D pistons 4.030" 24cc dish (good for blowers, nitrous, turbos, etc.)
ALL parts again, have NEVER been used.
Unsure what to ask for the parts, I jumped on summit to get retail prices. Here's what they're asking for them New in box
pistons $580
Rods $399
Crank $609
$1588 total plus possible shipping and/or tax..
I would like to see something close to $1000 for the parts. or make an offer. Thanks!
These should make a hell of a stout forged 355 capable of 700+ HP
I am located On the Illinois / Wisconsin Border right near Lake Michigan
I would prefer not to ship, as these parts would cost a ton in shipping weight
262-515-4321
call/text/PM
I have photos I can text / e-mail
- Eagle 4340 forged 350 crank (I believe it only is meant for a 1 piece rear main motor only) 3.48" stroke
- Eagle H-beam forged rods CRS-5700-BS with ARP fasteners
- SRP 40D pistons 4.030" 24cc dish (good for blowers, nitrous, turbos, etc.)
ALL parts again, have NEVER been used.
Unsure what to ask for the parts, I jumped on summit to get retail prices. Here's what they're asking for them New in box
pistons $580
Rods $399
Crank $609
$1588 total plus possible shipping and/or tax..
I would like to see something close to $1000 for the parts. or make an offer. Thanks!
These should make a hell of a stout forged 355 capable of 700+ HP
I am located On the Illinois / Wisconsin Border right near Lake Michigan
I would prefer not to ship, as these parts would cost a ton in shipping weight
262-515-4321
call/text/PM
I have photos I can text / e-mail
Thread
Thread Starter
Forum
Replies
Last Post
camaro98_speed
Suspension, Chassis, and Brakes
0
04-22-2015 11:26 AM