Deadcarny

I picked up this engine used and found 2 broke pistons, so I am parting what I have left out (prices do not include shipping):

Block, standard bore-
Crank, believe the rod journals are turned 0.030 (the Rod bearings say 0.030 on them).-

Rods X 16. I have 2 sets of rods, some have spun bearings, but more than 8 should be good. They have pistons on them, but 2 of the 16 pistons have broken skirts.-

Balancer-

Balancer Hub-

Timing cover (94-95)-

Flexplate-

Intake-

Injectors-

Wire Harness without Trans wires (good for a car with a TH350/TH400 swapped in!)- $SOLD

Sensors- E mail me which one you need

Oil pan-

Low Oil Sensor-

water pump-

Throttle Body-

Oil pump-

valve covers- (i have 3 sets I think)

Accy Bracket (looks like some holes need tapped)-

Tensioner-

Pushrods (hardened)- (I have 2 sets)

Lifters-

TH400 Transmission form 1967 SS. Needs rebuilt


If you need anything that is in the Motor and you do not see it here, E mail me at Deadcarny@SCFYB.com and ask if I have it. I think the only things I do not still have are the heads, Fuel Rails, and Opti.

Deadcarny

The Cam is gone as well.....

ALL PRICES ARE NEGOTIABLE! DON'T BE AFRAID TO E MAIL ME ANY REASONABLE OFFERS!

97ChameleonTA

What year motor? I'm looking for a harness and ECM from a '93.

Marty

Deadcarny

this was a 94

Kbird

I might be interested in the harness and ECM. What condition is the harness in? Cut wires, does it included all the sensor connectors and ECM connectors?
Thanks,
Kevin

Deadcarny

All it is, is the Engine Harness that goes across the engine and into the PCM. There are cut wires that I am pretty sure are the tranny wires. The PCM (1994 car) connectors are there. NO PCM.

Deadcarny

TTT...Prices are not set in stone.....more like sand.....come on and make some offers before the stuff hits e bay!

Deadcarny

Wire harness is SOLD! Thanks.
The rest of the stuff is still available. don't hesitate people!

Deadcarny

make me some offers on this stuff! i need to get rid of it all.

Black6SpdTA

I don't see any prices?

VERY interested in the block though, possibly the crank too. How many miles on everything? Any damage because of the broken pistons? I plan on punching it .030" over, will I be safe then. I'm in Mooresville, NC so we could probably meet. How much? Any pictures?

CScheip92@hotmail.com

-Corey

Deadcarny

No prices so people can make offers!

I would like $150 for the block.

Deadcarny

Don't see any damage from the pistons, the inside of the skirt is what broke. Looks like something got between the crank and skirt while it was spinning. I think the black has 117k on it. I can take pics tomorrow since it is at my work.

Black6SpdTA

If you could take pictures and get them to me tomorrow night, that'd be great. Hopefully I can meet you this weekend.

-Corey

Deadcarny

This weekend I will be On the road to deliver my car to New York since I sold it. I might could do it next week sometime though.

DarthIROC

Might you take $125 plus shipping on the block. Find out how much it would be to ship to 33569 in Florida.

And what kinda condition is it in?