FS: BMR Trak-Pak Torque Arm for 82-02 Fbodys
Thread Starter
Registered User
Joined: Aug 2002
Posts: 188
FS: BMR Trak-Pak Torque Arm for 82-02 Fbodys
BRAND NEW BMR Torque Arm, designed for 82-02 Fbody's.
Eliminate traction problems with the BMR Trak PakŠ. This design eliminates the transmission tailshaft stress by relocating the torque arm front mount. Shorter torque arm design moves the "instant center" rearward for improved weight transfer on acceleration. This kit consists of the adjustable torque-arm, a universal crossbrace, mounting hardware, and an anglefinder for adjusting pinion angle. Rear end mounting plates are made from strong, laser cut 3/8 " cold rolled steel. Equipped with a rear adjuster to allow on-car pinion angle adjustments up to 6 degrees for dragstrip tuning and a polyurethane front mount. Torque arm is made from 1.25" x .120" DOM tubing while crossbrace is made from 1-5/8" x .120" DOM tubing. Crossbrace requires welding and professional installation.
$340.00 obo, Email @ CoptzerZ28@hotmail.com, or AIM : CoptzerZ28
Eliminate traction problems with the BMR Trak PakŠ. This design eliminates the transmission tailshaft stress by relocating the torque arm front mount. Shorter torque arm design moves the "instant center" rearward for improved weight transfer on acceleration. This kit consists of the adjustable torque-arm, a universal crossbrace, mounting hardware, and an anglefinder for adjusting pinion angle. Rear end mounting plates are made from strong, laser cut 3/8 " cold rolled steel. Equipped with a rear adjuster to allow on-car pinion angle adjustments up to 6 degrees for dragstrip tuning and a polyurethane front mount. Torque arm is made from 1.25" x .120" DOM tubing while crossbrace is made from 1-5/8" x .120" DOM tubing. Crossbrace requires welding and professional installation.
$340.00 obo, Email @ CoptzerZ28@hotmail.com, or AIM : CoptzerZ28
Thread
Thread Starter
Forum
Replies
Last Post