$1500 PICKED UP or $1900 SHIPPED!!!

Up for grabs is a complete unit ready to bolt-in and go. I love this rear but it's just too hardcore for my taste. Instead of unwelding the Wolfe Drag Sway Bar (Good for 8's) tearin into it and throwing a TrueTrac in I'll cut my losses. If your looking to get the best ET possible with the strongest spool then this is for you. I'll even toss in the full spool and matching driveshaft! Unit was refreshened and given a clean bill of health with everything still in great condition. Documentation by builder will be provided. Pics are shown below.

Ford 9” Rear (31 Spline, 4.11 gears, Detroit Locker)
1/2" Long Wheel Studs
LT1 Backing Plates
LCA Relocation Brackets
Wolfe Drag Sway Bar
Strange Engineering Full Spool
1350 Yoke Driveshaft
$1900 SHIPPED! (from 92630 CA) If PayPal Add 3% For Fees.
Or
$1500 PICKED UP!

Will sell matching Driveshaft seperately for $250. Naturally 9" must sell first.

I just hope someone local wants this.

Ruben F.

Click on the image to view fullsize.

 

Im interested in the 9! Will this bolt up to my 1994 TA without any modifications??? where in socal are you located??

 

I'm located near Irvine. This was on my 94 and it was a direct bolt on.

Thanks.

Ruben F.

 

Locker or spool - you mention both? EDIT: looks like the Locker is installed and the strange spool is an extra?LT1 backing plates installed - just bolt on rotors/calipers and go?
how many miles/passes?

Can you pallet it and ship to Ct 06098 business?

 

Locker is installed, Strange Spool is Extra! Just bolt on rotors/calipers matching driveshaft and go! Oh, you will need 1/2" lugnuts for the rear.

Never been to a drag strip with the setup, just corner carving. Only two 30min runs. Mileage 4-5k and that's pushing it.

If the buyer pays for the pallet and shipping costs sure I can ship to a business from a business. I'll have to drain it to avoid the Hazard Fee. I'm honestly hoping someone local wants this to avoid the back injury.

Thanks.

Ruben F.

 

if you still have this in a week or mayyybe two i'll get it! Need to fix my crashed right fender on my 2000 SS

 

I know - shipping stinks - but it sually ends up that way!I put a motor for sale here in Connecticut and the ONLY buyer was in Washington state! He paid and that was about 245 bucks.
Can you pm a cost for your effort to strap it to a small pallet anda high estimate of frieght?
I've shipped rears and business to business if you have an account should only run 150-200 bucks.
That with driveshaft specs and some pics please to:
jplatt02@snet.net

thank you

 

can I get pics to rebel4life91767@yahoo.com

 

Pics are up!

Thanks!

Ruben F.

 

ALL PM's have been replied to!

Thanks!

 

All PM's Replied!

Thanks!

 

T T T

 

t T T

 

How is it gonna work? I have used pay pal on ebay before. How long is truck freight shipping gonna take to get hear you think?

 

ALL PM'S Replied To!

Thanks!

Ruben F.