3.75" Callies forged crank, Eagle 6" rods and Wiseco custom forged nitrous pistons
#1
3.75" Callies forged crank, Eagle 6" rods and Wiseco custom forged nitrous pistons
I am going to unload my Callies Stealth forged 3.75" one piece rear main seal crank and Eagle 3D 6" H-beam rods with upgraded ARP bolts that are attached to some custom Wiseco forged flat top pistons (-7cc/4.030) that have reliefs for 2.08/1.65 valves.
If someone wants the whole package I will let it go for 800.00 not including shipping.
I will seperate if someone is looking for just either or.
Crank - 400
Rods and pistons - 500.00 (Pistons alone were 800.00 new)
These rods and pistons have less than 5K miles on them and the crank not sure as I bought it in a motor. It was checked out when I had my motor built the last time and if I remember correctly the mains were turned .010 but I will have to check the bearings to make sure.
I paid roughly 500 for the rods and 800.00 for the pistons. I would say the crank was in the 1000.00 range new. So if someone is looking to do a stroker this would be a great setup made for some high HP for a cheap price.
If someone wants the whole package I will let it go for 800.00 not including shipping.
I will seperate if someone is looking for just either or.
Crank - 400
Rods and pistons - 500.00 (Pistons alone were 800.00 new)
These rods and pistons have less than 5K miles on them and the crank not sure as I bought it in a motor. It was checked out when I had my motor built the last time and if I remember correctly the mains were turned .010 but I will have to check the bearings to make sure.
I paid roughly 500 for the rods and 800.00 for the pistons. I would say the crank was in the 1000.00 range new. So if someone is looking to do a stroker this would be a great setup made for some high HP for a cheap price.
Thread
Thread Starter
Forum
Replies
Last Post