*NEW* 383 Stroker Motor $1500
Thread Starter
Registered User
Joined: Nov 2003
Posts: 7
From: AL
*NEW* 383 Stroker Motor $1500
Description: Eagle 383 stroker kit, reman 4 bolt main block, Comp 270H cam, 0 miles, asking $1500. Price includes the 383 short block + assembled heads. Compare to the HT383 for $4000! **WILL SHIP** Email me at nuclear_51@yahoo.com
*Adult assymbly req'd
*Adult assymbly req'd
Thread Starter
Registered User
Joined: Nov 2003
Posts: 7
From: AL
Ok, Let me start with this:
This means YOU, So dont ask how many miles is on it
The above price includes the cast crank, but I'll giveup my forged crank for another $300. Rods are 5.7 and the pistons are flats
The block listed is a 2pc. Then GUN4HIRE motivated me to make some calls and locate a 1pc block my friend has. So whoever wants the motor can have the 1pc or the 2pc block
see above
Actually, none yet. I'd probaly compare it to the GM perf parts 'HT383' motor with a Comp 270H cam. Heres a link with the HT383 http://royalpurple.com/hotrod2/hr2p1.html
. The block is a reman unit.
Darn good question... 
Hope this helps
Originally posted by turboman_013
*Adult assymbly req'd
*Adult assymbly req'd
Originally posted by Grover
Is this a fully forged kit? What are the length of the rods? Are the pistons flat or domed?
Is this a fully forged kit? What are the length of the rods? Are the pistons flat or domed?
Originally posted by gun4hire
LT1 or SBC? If SBC, 1pc rear or 2?
LT1 or SBC? If SBC, 1pc rear or 2?
Originally posted by RacerTim
Send me some more info too please. Forged, LT1..etc....
Send me some more info too please. Forged, LT1..etc....
Originally posted by tiger28
What kind of numbers will the engine put down? Is it fully forged? Is this a used motor with a rebuild on it?
What kind of numbers will the engine put down? Is it fully forged? Is this a used motor with a rebuild on it?
. The block is a reman unit.
Originally posted by Tekprodave
Everyone including me seems to want the same info. Why not just post it here?
Everyone including me seems to want the same info. Why not just post it here?
Hope this helps
Last edited by turboman_013; Jan 13, 2004 at 06:02 PM.
Registered User
Joined: Mar 2003
Posts: 526
From: Sacramento, CA
Originally posted by turboman_013
How about $1400?? Anyone??
How about $1400?? Anyone??
If it was an all forged, low compression motor setup for forced induction then I'd be all over it.