CamaroZ28.Com Message Board

CamaroZ28.Com Message Board (https://www.camaroz28.com/forums/)

- LT1 Based Engine Tech (https://www.camaroz28.com/forums/lt1-based-engine-tech-9/)

- - questionss?? (https://www.camaroz28.com/forums/lt1-based-engine-tech-9/questionss-341820/)

usredzcamaro

Feb 15, 2005 09:05 PM

questionss??

how much is it gonna cost me to get the heads milled on this lt1 engine? any1 have any rough estimates

1-bad-z28

Feb 16, 2005 08:09 AM

Re: questionss??

when you say milled do you mean decked for flatness? if so i payed $50 for the last set i had done. If you mean ported and polished it is several hundred depending on what you have done. When you start having bigger valves put in it gets pretty costly. I had a set priced for 2.02" I and 1.60" E valves and ported and polished for $800. All depends what you want and where you have them done.

All times are GMT -5. The time now is 12:15 AM.