EVAP purge solenoid check...
Thread Starter
Registered User
Joined: Feb 2003
Posts: 36
EVAP purge solenoid check...
I have the ohmeter set to AC and 200mV... it picks up a little bit of reading and when I touch the end together, it goes to zero. When I touch the two end to the ends on the EVAP solenoid it also goes to zero. Does this mean the solenoid is good, and that I need to keep looking on my SES#26?
Thanks, I'm not much of an electrical engineer.
Thanks, I'm not much of an electrical engineer.
Thread
Thread Starter
Forum
Replies
Last Post
jackpawt883
LT1 Based Engine Tech
7
Sep 10, 2015 08:53 PM
350350
Fuel and Ignition
14
Aug 11, 2015 12:03 PM
