How do I reset SES after changing MAF
Registered User
Joined: Sep 2002
Posts: 474
From: Las Vegas, NV
Provided by installuniversity.com and its creators.
Reminder: Make sure you have the keys out of the ignition. Why? When you remove the sensors from the air box lid assembly you do not want to start the car. You will set the Service Engine Soon (SES) light. If you do start the car without placing the sensors back in you can easily reset the SES light by following these steps:
1. Turn key to the "on" position but don't start car
2. Pull the PCM BAT and PCM IGN fuses in engine compartment
3. Wait approximately 5 minutes
4. Turn ignition off
5. Replace fuses
6. Start the car and then make sure the light has gone off
Reminder: Make sure you have the keys out of the ignition. Why? When you remove the sensors from the air box lid assembly you do not want to start the car. You will set the Service Engine Soon (SES) light. If you do start the car without placing the sensors back in you can easily reset the SES light by following these steps:
1. Turn key to the "on" position but don't start car
2. Pull the PCM BAT and PCM IGN fuses in engine compartment
3. Wait approximately 5 minutes
4. Turn ignition off
5. Replace fuses
6. Start the car and then make sure the light has gone off
Thread
Thread Starter
Forum
Replies
Last Post
carguyshu
Parts For Sale
20
Jan 22, 2017 11:19 AM
IgorT.455/406
LT1 Based Engine Tech
4
Mar 12, 2015 03:39 AM
armedtrigger
LT1 Based Engine Tech
10
Feb 24, 2015 08:30 PM
