Cheap Induction mods
Thread Starter
Registered User
Joined: Dec 2002
Posts: 156
From: TX/ DFW area
Cheap Induction mods
Newbie question. I am looking at the Aibox and wondering if I removed it. Removed the plastic panel behind the washer bottle,
If I could install a 3.5 tygon hose with a cone K&N and basically have all the advantage of the FIPK with cooler air from down below the washer bottle. Is there enough hood clearance in between the core support and the hood for this. This would connect straight to the MAF.
If I could install a 3.5 tygon hose with a cone K&N and basically have all the advantage of the FIPK with cooler air from down below the washer bottle. Is there enough hood clearance in between the core support and the hood for this. This would connect straight to the MAF.
Thread
Thread Starter
Forum
Replies
Last Post
Formula Steve
LT1 Based Engine Tech
45
Sep 19, 2023 08:31 AM