--------------------------------------------------------------------------------

I just finished my install on my 2002 Z28 and tried to close the hood. No go it hits the aftercooler and that is even with the bending the hood in the area the instructions showed it is like I am going to have to cut a section of the hood brace out all together for enough clearance? Not to mention that I installed a BMR K-member and that droped the motor down 1/2 to 3/4 of an inch. So I am wondering if anyone else has had an issue with this and also the discharge of the supercharger does not line up perfectly the aftercooler intake port it is resting on the intake and the supercharger is pointing downward about a little too much. What does everyone elses look like? any issues at all? Picture would be appreciated thanks.
__________________