F1R or F2 under '69 SS hood?
Thread Starter
Registered User
Joined: Jul 2003
Posts: 213
F1R or F2 under '69 SS hood?
I've built my 502 from the ground up as a blower motor, and I've installed my Hogan sheet metal intake, so its front-feed like a TPI style intake.
What I haven't been able to confirm is whether an F1R or F2 will fit under a stock SS 1969 hood (non-cowl-induction). I'm not too worried about the center (inlet) because the intake was designed for that purpose, but the F1/F2 case looks pretty big... and I won't be cutting any holes in my hood!
The only car with a similar setup that I've seen was Jody's with a D1SC, and from what I understand the inner fender needed to be cut and clearanced, which I'm ok with.
ATI can't tell me if it'll fit, and without the brackets and blower, I can measure off their diagrams but I'd be far more comfortable if someone had already installed one!
If anyone knows of an F1R or F2 on a big-block in '69, please let me know!
What I haven't been able to confirm is whether an F1R or F2 will fit under a stock SS 1969 hood (non-cowl-induction). I'm not too worried about the center (inlet) because the intake was designed for that purpose, but the F1/F2 case looks pretty big... and I won't be cutting any holes in my hood!
The only car with a similar setup that I've seen was Jody's with a D1SC, and from what I understand the inner fender needed to be cut and clearanced, which I'm ok with.
ATI can't tell me if it'll fit, and without the brackets and blower, I can measure off their diagrams but I'd be far more comfortable if someone had already installed one!
If anyone knows of an F1R or F2 on a big-block in '69, please let me know!
Registered User
Joined: Feb 2002
Posts: 5,645
From: Bridgewater, MA
Pretty sure I have seen one or two build on www.turbomustangs.com
Definitely check over there as well.
Jon
Definitely check over there as well.
Jon
Thread
Thread Starter
Forum
Replies
Last Post
CARiD
Supporting Vendor Group Purchases and Sales
0
Sep 30, 2015 05:44 AM
