Gauging Interest- '94 Trans Am M6
 

1994 Trans Am:

• M6
• Cloth Int.
• 73,xxx miles
• Hardtop
• LS1 Taillights
• Powdercoated LS1 T/A rims
• 30% tint (due for a re-tint soon)

Engine/Exhaust:

• Pacesetter Ceramic coated long tubes/ORY
• Borla Fully adj. catback
• SPEC Stage II clutch
• Pro 5.0 short throw shifter
• Spiral pro 8.5mm wires
• LT4 Valve covers
• Comp 1.7rr's
• [not installed]Moroso CAI
• PCM Tune by Bryan @ PCM4Less
• LS1 Aluminum driveshaft
• !EGR/!AIR
  

Suspension:

• AGX adjustables on all 4 corners
• Eibach Pro-kit lowering springs
• [not installed]drilled/slotted rotors
• Several new OEM suspension pieces
• [not installed]tubular BMR LCA's/relocation brackets (weld-in)

The paint/overall exterior is very nice for the age of this car. I had the front/rear bumpers resprayed about ~2k miles ago (due to the typical oxidation of the paint on these cars). The driver side door was also re-sprayed at the same time as I had a small dent pulled (painter did a very good job of blending the paint). There are a few rock chips/small knicks, etc as I did drive this car quite often.

The car had the SPEC II clutch installed only ~100 miles ago, so it is not fully broken in (I would like to put a few hundred more miles on the vehicle before selling, to ensure that everything is reliable). Any questions feel free to PM/email me @ spitfire557@gmail.com.

ASKING PRICE: $5900

Attachment 35166
Attachment 35167
Attachment 35168