97 Camaro SS #179 22k original miles Project
#1
97 Camaro SS #179 22k original miles Project
Red/charcoal SS, 22k original miles M6
engine is currently out of the car, engine was just built by Golen. Forged 383, SRP pistons, 12.4:1 compression, LE3 cam 24x/25x on a 109, Extreme duty timing chain, le3 lt4 heads with 2.06 valves, comp promag rockers etc etc. LE modified and ported lt1 intake modified to fit lt4 heads.
Car has been sitting a few years as I have too many other projects. Was planning on doing a crazy build on this so I sold some parts that I had. A few things will be needed to complete the build along with assembly. Currently the long block is assembled.
car has 4.10 gears, tubular rear lca’s, welded on lca relocation brackets, Borla catback, aluminum 1le driveshaft, abs was deleted but have ALL stock parts including brake lines, a/c deleted but again have ALL stock parts, many billet aluminum under hood and interior dress up parts, pro 5.0 shifter, McLeod clutch, tubular k member with tubular upper and lower control arms, SLP level 2 suspension, I have original ss zr1 wheels along with chrome 18” c5 z06 wheels.
parts needed to complete; throttle body, pushrods, crank position sensor, valve cover gaskets, intake gaskets and bolts, tb gasket and bolts.
asking $14k obo. Body and interior of this car is MINT no paintwork and the car is STRAIGHT.
engine is currently out of the car, engine was just built by Golen. Forged 383, SRP pistons, 12.4:1 compression, LE3 cam 24x/25x on a 109, Extreme duty timing chain, le3 lt4 heads with 2.06 valves, comp promag rockers etc etc. LE modified and ported lt1 intake modified to fit lt4 heads.
Car has been sitting a few years as I have too many other projects. Was planning on doing a crazy build on this so I sold some parts that I had. A few things will be needed to complete the build along with assembly. Currently the long block is assembled.
car has 4.10 gears, tubular rear lca’s, welded on lca relocation brackets, Borla catback, aluminum 1le driveshaft, abs was deleted but have ALL stock parts including brake lines, a/c deleted but again have ALL stock parts, many billet aluminum under hood and interior dress up parts, pro 5.0 shifter, McLeod clutch, tubular k member with tubular upper and lower control arms, SLP level 2 suspension, I have original ss zr1 wheels along with chrome 18” c5 z06 wheels.
parts needed to complete; throttle body, pushrods, crank position sensor, valve cover gaskets, intake gaskets and bolts, tb gasket and bolts.
asking $14k obo. Body and interior of this car is MINT no paintwork and the car is STRAIGHT.
Last edited by cmroSS97; 05-08-2021 at 02:23 PM.
Thread
Thread Starter
Forum
Replies
Last Post