Front door speaker trim
The door is usually attached by a series of pop-screws and also some screws located in places around the door handle... I haven't taken apart my door panel to replace the speakers yet but I'm planning on doing it soon. I have done it in other cars and they were all the same. When you locate all the screws and pop off all of the pop-screws then typically you have to lift up on the door panel before you can remove it. I will let you know more information as I get it.
Originally posted by PaulN64
you actually have to remove the door panel to get to them.
you actually have to remove the door panel to get to them.
Thanks for the replies everyone. I didn't realize all the work involved.
So how did you get the covers back on?
Originally posted by rockcamaro97
u can take the cover off but it has to be cut off. Just use an exacto knife if u wanna remove it. U still cant get to the speakers though. I did this to paint them.
Matt
u can take the cover off but it has to be cut off. Just use an exacto knife if u wanna remove it. U still cant get to the speakers though. I did this to paint them.
Matt
So how did you get the covers back on?
I managed to remove my stock door speakers and put new ones in though the grill hole. Though, my stock speakers were only mounted with 2 screws
The car had some badly done system in it when I bought it. Go figure. So, I just mounted the speakers with the screws that were there. When they get louder, the vibrated some though. So, when I get my car back from the shop (I hope this weekend! Its been almost 3 months! I miss my car!) I'm gona pull the door panels off and mount them better. Doing this along with a full tune up (Minus plugs, cuz my wires aren't here yet)
The car had some badly done system in it when I bought it. Go figure. So, I just mounted the speakers with the screws that were there. When they get louder, the vibrated some though. So, when I get my car back from the shop (I hope this weekend! Its been almost 3 months! I miss my car!) I'm gona pull the door panels off and mount them better. Doing this along with a full tune up (Minus plugs, cuz my wires aren't here yet)
Thread
Thread Starter
Forum
Replies
Last Post
Wilson
Car Audio and Electronics
0
Jul 21, 2002 05:08 PM



