4 bolt block, accessories, headers, and PCM for sale
#1
4 bolt block, accessories, headers, and PCM for sale
I have the following for sale:
4 bolt main 360cid (bored 60 over) LT1/LT4 short block assembly. Fully functional, will be removed from perfectly running car on Saturday the 28th. This shortblock has less than 500 miles on it including the block. Comes with all internals except cam. Thats pistons, rods, rings, crank. All assembled and ready for heads and cam. Everything is aftermarket non-forged.$1000
PCM, programmed to run an LT4 engine with a CC306 cam and Yank PT3600 stall converter w/ headers and true duals etc... $150
Power Steering pump $25
Alternator ('95 Z) $50
A/C compressor, lines, dryer, condensor $150
Tensionor $50
Starter $25
Steel Driveshaft $100
LT1 stock K-member $100
LT1/LT4 Ceramic coated Hooker Super Comp LT Headers $450
Comp Pro-Magnum 1.6 Roller Rockers Self Aligning Part #63-1318-16 $225
LT1 oil pan $20
4 bolt main 360cid (bored 60 over) LT1/LT4 short block assembly. Fully functional, will be removed from perfectly running car on Saturday the 28th. This shortblock has less than 500 miles on it including the block. Comes with all internals except cam. Thats pistons, rods, rings, crank. All assembled and ready for heads and cam. Everything is aftermarket non-forged.$1000
PCM, programmed to run an LT4 engine with a CC306 cam and Yank PT3600 stall converter w/ headers and true duals etc... $150
Power Steering pump $25
Alternator ('95 Z) $50
A/C compressor, lines, dryer, condensor $150
Tensionor $50
Starter $25
Steel Driveshaft $100
LT1 stock K-member $100
LT1/LT4 Ceramic coated Hooker Super Comp LT Headers $450
Comp Pro-Magnum 1.6 Roller Rockers Self Aligning Part #63-1318-16 $225
LT1 oil pan $20
Last edited by '95 LS1 Z28; 02-28-2004 at 02:11 PM.
#3
I am not sure of the complete condition. They have been on the car for 500 miles. They will be off this weekend and I will try to upload some pics for you. They should be in perfect condition. The only marks that they *might* have is on the bottom where they may have drug over stuff.
#5
I am in Justin TX out by the Texas Motor Speedway. But I work in Lewisville right down the road from RPM so you can pick up there if needed. I could also meet you in Grapevine or Southlake. Let me know what you need and we will work it out. I will get pics this weekend sometime or if your close then you can come take a look for yourself.
Thread
Thread Starter
Forum
Replies
Last Post
chevroletfreak
LT1 Based Engine Tech
202
07-04-2005 05:00 PM