B&M Ripper Question
#1
B&M Ripper Question
Hey, I've got a 97 Camaro 3800, intake and exhaust and I recently installed the B&M Ripper T5 short throw shifter. The shifter works great and makes a huge difference in the throws and overall feel of the drive. With this said, at high RMP's, somewhere close to 4000, it begins to make a rattling noise. There is no noise at idle or no noise even up to this point. I was just wondering if this is normal or if I'll have to go back in and replace something, possibly the bearing where the shifter meets the tranny. Thanks for the help.
#2
Re: B&M Ripper Question
Originally Posted by MikeJules21
Hey, I've got a 97 Camaro 3800, intake and exhaust and I recently installed the B&M Ripper T5 short throw shifter. The shifter works great and makes a huge difference in the throws and overall feel of the drive. With this said, at high RMP's, somewhere close to 4000, it begins to make a rattling noise. There is no noise at idle or no noise even up to this point. I was just wondering if this is normal or if I'll have to go back in and replace something, possibly the bearing where the shifter meets the tranny. Thanks for the help.
it'll have no detremental effect on ur car, so just replace the bearing when u have time, i'm assuming u installed it urself, so trust me, it gets quicker everytime u take off/install one of those shifters (it now takes me 30 mins total, my 1st install took 2 hrs )
Thread
Thread Starter
Forum
Replies
Last Post
Hurin
Suspension, Chassis, and Brakes
4
12-13-2014 07:38 PM
lbrowne
LT1 Based Engine Tech
25
11-13-2011 04:25 PM