Built T56 conversion for LT1 F-body
Thread Starter
Registered User
Joined: Apr 2004
Posts: 309
From: Detroit
Built T56 conversion for LT1 F-body
I have an entire T56 conversion for a sbc/Lt1 4th gen f-body without the clutch assembly
includes:
T56 w/ bell-housing built by Liberty with D&D viper output shaft conversion, steel 3-4 shift lever, and B&M short throw shifter
has less than 1000 miles on trans since rebuild with upgrades
Pedal Assy for 4th gen F-body
McLeod Clutch Master Cylinder
Factory Slave cylinder
Transmission Crossmember
Rubber boot for floorboard
Wiring harnesses to splice in
3.5" steel Driveshaft with yoke for big outout shaft and ford 9" rear in 4th gen f-body (not in pic)
$2400
Located in Westland, MI
includes:
T56 w/ bell-housing built by Liberty with D&D viper output shaft conversion, steel 3-4 shift lever, and B&M short throw shifter
has less than 1000 miles on trans since rebuild with upgrades
Pedal Assy for 4th gen F-body
McLeod Clutch Master Cylinder
Factory Slave cylinder
Transmission Crossmember
Rubber boot for floorboard
Wiring harnesses to splice in
3.5" steel Driveshaft with yoke for big outout shaft and ford 9" rear in 4th gen f-body (not in pic)
$2400
Located in Westland, MI
Last edited by z28draco; Jul 2, 2008 at 10:33 AM.
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
Oct 31, 2016 11:09 AM