I had BMR boxed sub frame connectors welded in on monday in hopes of getting rid of some of the noises i had, now I have more when going over large bumps. I immediately figured that they just didn't torque the bolts down enough and got it in the air to check them. But now, due to the SFCs going around the body side LCA bracket and moving the bolt ******d about a 1/4" i have no room to get a torque wrench in there. I could only fit my breaker bar in there and figured i would just tighten it until i couldn't anymore. That got rid of the loud noise when going over big bumps but i still have some noise. Could it just be because the SFCs are not letting the chassis absorb some of the bumps? I'm about to just go and buy all new rear suspension parts in an attempt to get rid of these noises.