Hey Guys,

Well i am selling off everything, i have all the right parts here to make a 600-1000hp car all hi-end parts SO PLEASE NO LOW BALLERS

This is off my 95 T/A

I HAVE PICS OF EVERYTHING I WILL POST OR I CAN EMAIL THEM

Vortech cog pulleys 36mm, 78 teeth crank/30 blower

custom 4" suck side and air filter

vortech mondo BOV

Alky control kit
singal kit & new dual kit as well, with an new extra pump $440

Nitrous Outlet elbow for Vic intake i will through this in with the heads and intake

Vic Jr intake with fuel rails its fully ported and matched to the heads this stuff is a one off
matching AFR 220 heads
These are Z8's old AFR heads(220) that were ported by GTP that flow 330cfm@.600 and mating Vic intake you will not find another set of heads like this with shaft mounts 1.7r $3000.00


sphoon TQ arm $350


ATi extra keyed crank hub / balance
e-water
custom Bret B blower cam
Morrel's lifters

MAKE OFFERS ON ENG OR I CAN PART OUT



drive shaft for M6 tranny to match up with the 9" to handle 1000hp $300.00

weld wheels

15x10.5 with 7.5 bs $300 and hoosher slicks $100


IF DOING PAYPAL ADD 3%

obo

 

ttt

 

ttt

 

ttt

 

ttt

 

I cant believe that you cant sell the top end I had over $10k into that setup. This setup will make killer power for anyone looking to make big power. This isn't your run of the mill stuff, many many hours of hand porting here. Good Luck on selling it Jeremy

 

thanks Chris

 

I'm amazed you still have those heads and intake. When you first posted them I was tempted to take out a loan for them...I want them bad but have way too many expenses now.

If only it was closer to tax returns!!!

 

I'd be on that setup like white on rice if I knew I could sell my AFR 210's for a halfway-decent price. I remember you telling me about that setup, absolutely killer and a fantastic deal.

 

ttt

 

ttt

 

Are the wheels prostars and what are the cc on the heads??

 

yes they are pro stars
67cc

 

ttt

 

ttt