F/S: Performance CNC Heads/Rockers/Pushrods
#1
F/S: Performance CNC Heads/Rockers/Pushrods
Recently purchased a complete motor, so won't need these anymore. These heads worked awesome! Bought from Scoggin Dickey Performance about 4 years ago. These are factory castings (10207649) that have been completely CNC'd ported. Bowls are 57cc. Sorry, I'm not sure of the runner volumes. Valves are stainless, 2.00/1.56. Comp springs (good for 600 lift), titanium retainers, 7/16 rocker screw-in studs with Comp Cam guide plates. Heads flowed 255 cfm on my buddy's flow bench.
Rockers are Comp Pro Mag #1108....1.55 Ratio.
Pushrods are Comp Cam #7944. Length is 7.250.
With the 218/230 495/510 114 blower cam, my car made 512 rwhp with 6psi of boost on stock bottom end. With 8-9 psi of boost, car went 124.5 mph in the quarter.
Asking $900 for everything.
Rockers are Comp Pro Mag #1108....1.55 Ratio.
Pushrods are Comp Cam #7944. Length is 7.250.
With the 218/230 495/510 114 blower cam, my car made 512 rwhp with 6psi of boost on stock bottom end. With 8-9 psi of boost, car went 124.5 mph in the quarter.
Asking $900 for everything.
Last edited by robyyzpapa; 12-22-2015 at 08:22 PM.
Thread
Thread Starter
Forum
Replies
Last Post