27 spline to 30 spline swap question
#1
27 spline to 30 spline swap question
I was hoping one of you guys could answer this question about a 700R4 trans. When I built my trans I used all good parts except I didn't have a 30 spline so I used a 27 spline input shaft that I had, now I want to swap to a 30 spline input shaft and I am not sure if there is anything else I would need to change other than just getting a new input shaft. If anyone knows of anything else that needs to be changed please let me know.
Thanks,
John
Thanks,
John
#3
Re: 27 spline to 30 spline swap question
Mike I haven't figured out how to stuff 30 splines into 27 in the converter yet??
The stator in the torque converter is the only other thing that I'm aware of. It's far more cost effective too send the converter in to have this done than purchase a whole new converter. Stators run 40~80 buxs then another 120~200 too have the converter cut open too install it then weld, rebalance it.
QUOTE=jp2002ls1]I was hoping one of you guys could answer this question about a 700R4 trans. When I built my trans I used all good parts except I didn't have a 30 spline so I used a 27 spline input shaft that I had, now I want to swap to a 30 spline input shaft and I am not sure if there is anything else I would need to change other than just getting a new input shaft. If anyone knows of anything else that needs to be changed please let me know.
Thanks,
John[/QUOTE]
The stator in the torque converter is the only other thing that I'm aware of. It's far more cost effective too send the converter in to have this done than purchase a whole new converter. Stators run 40~80 buxs then another 120~200 too have the converter cut open too install it then weld, rebalance it.
QUOTE=jp2002ls1]I was hoping one of you guys could answer this question about a 700R4 trans. When I built my trans I used all good parts except I didn't have a 30 spline so I used a 27 spline input shaft that I had, now I want to swap to a 30 spline input shaft and I am not sure if there is anything else I would need to change other than just getting a new input shaft. If anyone knows of anything else that needs to be changed please let me know.
Thanks,
John[/QUOTE]
#6
Re: 27 spline to 30 spline swap question
Thanks guys, sounds like I just need a new torque converter, input shaft, and pump stator. I appreciate the input, I would have forgot about the pump stator. I built my trans up with all the good parts except for the input shaft but now I wanted to get a bigger stall and I also have to upgrade the input shaft.
Last edited by jp2002ls1; 04-27-2005 at 10:03 AM.
Thread
Thread Starter
Forum
Replies
Last Post
importkiller94
General 1967-2002 F-Body Tech
0
01-17-2015 09:03 PM