RX7 LT1 swap almost done
#1
RX7 LT1 swap almost done
I have been working on an LT1 engine swap in my RX7 for a few months. Its almost done by now. I wanted to share a few pictures:
The car:
Engine bay top view:
Driver side view:
Pass side view:
The car:
Engine bay top view:
Driver side view:
Pass side view:
#3
I weighted my FC before the swap and it tipped the scales at 2758 lbs. After the swap it is supposeg to gain about 100 lbs.
The engine was bored .030 over and decked to .005" in the hole. ARP rod bolts and new bearings.
A pair of LE2 heads are sitting on top of the decks and small LE cam with a ported intake and 58mm TB complete the top end.
The engine was bored .030 over and decked to .005" in the hole. ARP rod bolts and new bearings.
A pair of LE2 heads are sitting on top of the decks and small LE cam with a ported intake and 58mm TB complete the top end.
#5
Re: RX7 LT1 swap almost done
I've been driving around for a year now and am very pleased with the end result. It has turned into a never ending project though.
Here a few pictures of the actual status of the car:
Here a few pictures of the actual status of the car:
Thread
Thread Starter
Forum
Replies
Last Post