Low beam headlights for 95 camaro? - CamaroZ28.Com Message Board

Go Back   CamaroZ28.Com Message Board > 1967-2002 F-Body Technical Discussion > General 1967-2002 F-Body Tech

Reply Post New Thread
LinkBack Thread Tools Search this Thread
Old 11-03-2013, 06:06 PM   #1
Registered User
Join Date: Jun 2013
Posts: 75
Low beam headlights for 95 camaro?

Like stated in the title I need new head lights. I started my car at 3am and flipped the lights on, heard a static sound and my front left light blew out.

Im looking to get a new light but was curious if the light bulb itself only needs to be replaced or if I need a new housing for the bulb too?

If anyone has any recommendations for a good set of lights feel free to say

95 Z28 Camaro lt1, Tick rebuilt T56, PCMforLess tune, Lt4 Hotcam, 1.6 Scorpion roller rockers, Compcams push rods, Hooker super comp shorties, Flowmasters 3 inch cat back, K&N CAI, Zr1 17X11's Rear and ZR1 17X9.5s Front.... Misc parts: Belden edge Spark plug wires, NGK spark plugs, AC delco fuel filter, acdelco fuel pump.
MDZ28 is offline   Reply With Quote
Old 11-03-2013, 09:24 PM   #2
Registered User
shoebox's Avatar
Join Date: Dec 1969
Location: Little Rock, AR
Posts: 27,348
Re: Low beam headlights for 95 camaro?

It is a sealed beam light like the old days (and expensive).
shoebox is offline   Reply With Quote
Old 11-05-2013, 04:21 PM   #3
Registered User
Premium Member
KYWes's Avatar
Join Date: Mar 2003
Location: Louisville, KY
Posts: 270
Re: Low beam headlights for 95 camaro?

As Shoebox said it is a sealed beam bulb...however it is possible to replace just the bulb. I did this to '95 Z28 and upgraded my bulbs to Sylvania Ultra Star for the brighter beam. You will need to carefully remove the old bulb from the sealed beam. Then I installed a new bulb and RTV'd it on. It's been going several years now with no problems. I think the low beam bulb is a 9006. Just check to make sure the wiring socket has the same configuration. This should be done in pairs so your headlights will match. I waited until two of my lights went out and then I made the change.
1995 Z-28 Convertible M6, Bilsteins, K&N FIPK, Holley 52mm throttle body, Mac Mid-length headers, Y-pipe and ORP, Borla cat back, Comp Cam 07-466-08 cam (218-224 @ .050), Comp Cam 1.6:1 RR, LS1 aluminum driveshaft, Founders Performance rear LCAs and Panhard Rod. 12 bolt Strange rear end with 3.73 gears and B&M differential cover. Removed air pump and EGR. Added Accel ignition coil and Taylor plug wires with the OVC wire kit.
KYWes is offline   Reply With Quote
Reply Post New Thread

Similar Threads
Thread Thread Starter Forum Replies Last Post
Twin Turbo Kit and 355 for sale LeftoverChinese Parts For Sale 21 09-30-2015 02:35 PM
Eagle H-beams, 643 heads, gudeplates/studs Catmaigne Parts For Sale 4 12-25-2014 12:16 PM
odds and ends CaRParts102 Parts For Sale 0 12-06-2014 08:45 AM
New! Total Blackout (or colors/CF) Decal Kit for 2010-13 Camaro @PFYC-PartsForYourCar PFYC Supporting Vendor Group Purchases and Sales 0 12-04-2014 11:56 AM
1996 Trans am part out siguy Parts For Sale 3 11-27-2014 10:07 AM

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT -5. The time now is 11:30 PM.


Copyright © 1996-2013 CamaroZ28.Com. All rights reserved.