Wilson

I got a 93 Camaro and im looking for the speaker size for the front doors and the rear sail panels. Also, what's a good efficient 2 or 3 way speaker to get to fit in thoses locations? Im going to run it off my Eclipse deck (30x4). I already have Aura separates in the custom kick panels and a JL 10w6 sub in the rear hatch. So, im not looking for anything really extreme, just good, reasonability priced speakers that are efficent off the deck's power. Thanks!

------------------
93 Z28 w/ ZR28Kit & Fx-5 Suspension, 17" SS rims, LS1 brakes w/braided lines, 1LE Swaybars, slotted rotors, Custom Chip by ME, pullies, ASM 52mm, CC 1.6 non-aligning 7/16 rockers, ported heads, Mezeire waterpump,SLP headers w/2100* PBM coating, 24#SVO injectors, Metco afpr w/fuel rail gage,OverMade4You wire looms & custom wires ,LT4 Valve cover,etc....To many to list
Check out my homepage at:
My Website
***NEED TO INSTALL***
LT4 Hotcam,TransGo shiftkit

robert_T

They are both 6.5"

Zomie

Actually they are 6 3/4, I learned the hard way by ending up drilling two holes in my JBL's when I got them to make them fit!

------------------
95 Camaro 3.4L M5,
-Flowmaster muffler 80 series with quad tips,
-White Racing Stripes
-LeBra front end cover,
-Interior purple neons
-2000 Trans Am rims
-Car audio
180 Watt Kenwood head unit
jbl's all around
2 10" Jensen 375 watt subs with a 250 watt amp (I know its cheap but I really don't want to kill any little old ladies)
http://members.glis.net/zomie

CobraEatr

Zomie is right. I just read in Crutchfield that the stock speaker size is 6.75" all the way around.


------------------
93 Z28 M6
116K, MAC Headers, Y-Pipe, Off-Road Pipe, K&N FIPK, Dynomax Ultra Flow Welded Muffler,
TB Bypass, Taylor Wires, Bosch Platinum Plugs, Homemade Air Scoop, K&N Oil Breather,
!Silencer, !EGR, !AIR

My 1993 Z28 Webpage

Wilson

So, all you had to do was drill new holes in the speakers? Do you have to fab any new brackets to make it fit in the rear sail panels or in the doors?

Wilson

Do they even sell a 6.75" speaker? Or do you just have to redrill the holes in the 6.5"?

Zomie

Yes they sell 6.5 / 6.75 inch speakers. You need to make sure that its capable of being 6 3/4 or you will be drilling holes like me!

I drilled two holes at the edge of the speakers so that the space was the same as on the stock ones and mounted it with only two screws, they sound fine and I did not damage the speakers any, Just one huge pain when I thought they would just bolt on!

[This message has been edited by Zomie (edited July 21, 2002).]

Wilson

Thanks guys!