Timeslip within, do these #s seem good for my mods?
Thread Starter
Registered User
Joined: Jul 2000
Posts: 959
From: Green Bay, WI
Timeslip within, do these #s seem good for my mods?
Ok, the car is a 6spd and I know my 60ft. could be better, but this year I'll have Nittos so we'll see what happens. This run was with mid 60 degree weather, and calm wind. So what do you guys think. Mods are in sig.
Aaron
60ft-----------> 2.107
1/8 mile------> 8.559@84.683
1/4 mile------> 13.164@107.035
Aaron
60ft-----------> 2.107
1/8 mile------> 8.559@84.683
1/4 mile------> 13.164@107.035
Registered User
Joined: May 2002
Posts: 37
From: Minneapolis, MN, USA
Have you dynoed your car yet? I'm just curious what kind of hp you're putting down cause I have almost the exact same setup and will be getting the hotcam this month. Times look good, hopefully the dr's will get you into the 12's.
Registered User
Joined: May 2002
Posts: 37
From: Minneapolis, MN, USA
I think you should be at the very least 315-320 with the M6, tuning, hotcam, headers, and other bolt ons. That's just based on what I've read on here though...I sure hope I get more than 300-305.
Registered User
Joined: Jul 2002
Posts: 924
From: SE Michigan
Registered User
Joined: Apr 2002
Posts: 552
From: San Antonio, Texas
I dont think that you are going to be quite that high on your RWHP. I would say 280-290 RWHP would be a better guess.
As you are already aware its your 60 foot that is keeping you from hitting 12's. Hit a 1.9xx 60 foot and kiss a 12.9xx time slip.
But I must say thats a nice time with just those few mods.
As you are already aware its your 60 foot that is keeping you from hitting 12's. Hit a 1.9xx 60 foot and kiss a 12.9xx time slip.
But I must say thats a nice time with just those few mods.
Banned
Joined: Aug 2001
Posts: 3,505
From: looking for a flow bench so Brook and I can race
Originally posted by 94 CAMRO Z28
Im sure its running more then 280-290hp. I dont know if that would be enough to trap 107mph. And trey, your just a freak thats all...
Im sure its running more then 280-290hp. I dont know if that would be enough to trap 107mph. And trey, your just a freak thats all...
Texas Moderator (1998-2009)
Joined: Dec 1998
Posts: 1,301
From: DFdubya, Tx.
I'd figure your mph to be a little higher since you've got a cam and all.
Running the same/similar mods as you (Only no hotcam - factory cam) ~ I ran a 12.8@108. Jordon squeezed in a 12.7@108 w/ the same thing.
Running the same/similar mods as you (Only no hotcam - factory cam) ~ I ran a 12.8@108. Jordon squeezed in a 12.7@108 w/ the same thing.