Turbo Intake Elbow - Suggestion Needed for Tight Clearance *pic*

I was hoping to get some feedback on some sort of turbo inlet plumbing I could run with this setup. Inlet faces drivers side fenderwell.

Picture taken looking down from drivers side. Notice the screen over the inlet :)

http://i296.photobucket.com/albums/mm187/boosted-lt1/DCFC0040.jpg

I think even the cobra head would be tight. What do you think?

http://intakehoses.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=90CB40&Category_Code=CHEW


Thanks,
Scott.

that's as bad as mine, I havent attempted to put anything in there, still running the screen

Eww, less room than mine. I don't think the cobra one will work in your case, it might on mine.

Might be stuck with a screen. Maybe try to build some sort of splash guard? I don't even think the aem ricer mushroom filter will fit. Its pricey and the Supra guys love it. Check it out.

flex tubing (like dryer hose) and relocate the filter somewhere else. Your turbo faces backwards, so a screen should be OK for mild street use.