Anyone have an AutoCAD dwg for header flange?

Looking for either a SBC or LT1 Dport header flange drawing. also if anyone has a T6 flange drawing that would be nice to :)

turbotank AT Gmail DOT com

Looking for either a SBC or LT1 Dport header flange drawing. also if anyone has a T6 flange drawing that would be nice to :)

turbotank AT Gmail DOT com

Just make one, it shouldn't take more than 15 minutes to make a drawing like that. Heck you could do it in 5 with Solidworks.;)

Go get a gasket if you need the dimensions.

Go get a gasket if you need the dimensions.

thats what I planned on doing but if someone had already done it then why bother :)

thats what I planned on doing but if someone had already done it then why bother :)

I hear ya, but if it were me, I wouldn't trust someone else's drawing to be accurate.

Sounds like you are designing a turbo hot side? If your starting point is off, the whole thing will end up off, and if this is going into a 4th gen Fbody you don't have a whole lot of room to begin with.

Just my $.02, if I had an SBC flange I'd hook you up, but all my stuff is either Nissan, Kawasaki, or LSx. And most of it is in Solidworks anyway.

good point, ill take my own measurements. yup starting with the hot side, and its going into a thirdgen so theres a little more room to fudge stuff.