Y or T fittings for Fuel Rail setup.

I am setting up my -an fuel rail setup and am running the fuel rails in parellel but I can't find a Y fitting so that I can split my feed line across to both of my fuel rails....

I can find T fittings everywhere but I figured those wouldn't flow neary as well as a Y fitting and might even be intrusive. If this isn't the case then I will go with a T fitting but I would prefer a Y fitting.

If anyone can point me in the right direction that would be greaty appreciated. I need a Y for both -8an and -6an

Here ya go:
http://store.summitracing.com/egnsearch.asp?N=700+4294924496+4294839052+115+4294 849578

Thanks, that is exactly what I was looking for, don't know why I couldn't find them yesterday. When I was searching.

I use a russel on my fuel feed line, that has a 1/8 port built in there if your running a fuel pressure gauge. Im not running a Y back out of my rails, I run both lines back into the regulator instead of Ying it and capping one side off.
http://store.summitracing.com/egnsearch.asp?Ntt=Russel+Y&searchinresults=false&Ntk=KeywordSearch&DDS=1&N=700+4294924496+4294839052+4294849578+115

http://www.streetlethal.net/EFI/IMG_2782.JPG